EVO ALL won't recognize keys on 2019 Ford Explorer during programming

Question

Evo all standalone wire to wire with t-harness firmware 71.52(i have also tried 71.49, 4.01, 7.47, and programming related to listed firmwares) I am trying to do 2 key programming. When I get to the step of holding(the folded key) to the ignition, press the button on EVO, nothing happens. Nothing progresses. Any ideas for where I need to look? CAN bus is wired and voltage tested good. Wires were stripped, wrapped, and taped. Module does seem to communicate with vehicle with key fob sending lock/unlock(blue LED lights up) functions, then doing the lock/unlock/lock, it flashes 5 times RED which i know means hood open. Not sure why as the toggle switch has a good ground and is turned off. The toggle is wired into the dark blue A8 wire on the 20 pin connector. Please advise

Answer 1

The programming with the FOR2 harness requires 71.52. It also requires that you connect the Purple/Yellow to the Yellow

71.49 is a different programming.

4.01 is a completely different install and programming.

 

5 flashes is hood open. This will happen if either there is a ground signal on A8 or if the module is detecting the hood open on CAN.

 

So, what is the service number of the module and which t-harness are you using ?

Comments

Service number 001A07186626. The T-harness I have only requires me to hook up CAN1 hi/lo and CAN 2 hi/lo, along with the t-harness that goes to the ignition barrel. There are not any other free wires to connect to anything. Please advise