Questions & Answers

evo one firmware version updating to recommended version but showing 0.00 after flashed

0 votes
evo one firmware version 1.24 was compatible when i plugged it to flashlink again to make some setting changes but now showing firmware is not compatible so i update to recommended firmware 1.25 but now firmware is showing 0.00 after updated to flashlink and still flashlink is suggesting to update to recommended firmware 1.25. so i updated to 1.25 version again and still showing 0.00 after flashed. i lost 3x chance flashing in this hardware on the remote starter side. anybody can tell me what is going on about flashlink or my hardware..
posté Jan 30, 2020 dans la catégorie Dodge par Kid Ratits (470 points)

1 Réponse

0 votes
what is the service number of the evo-one?
répondu Jan 30, 2020 par Robert T (300,020 points)
Service# 002B07034481
Thanks Robb! firmware is now updated!

It shows as being updated on my end.  Restart flash link? Make sure you have 4.51 installed. 

 

 

 

i can't get solid blue led on programming step 1 to 3 when i release the programming button blue led will off for 2008 dodge ram 2500 diesel. i checked all my wiring and they are on the right connection aside parking light i didn't use it. am i on the right firmware? i don't think i can still flash my firmware on the bypass side i has 8/8 already
If blue turns off by itself after releasing on blue, it's because the module sees ignition on already. Check your A1-yellow and e5 pink connection. Meter the wire as well. should only be 12v when key is on.

 

Your module is reset.
could I get a module reset as well. I am stuck with a red LED on only and can not do anything.  any help would be appreciated.s/n 001A07 200763

It was preprogrammed with the following:

Firmware: 70.XX

type GMC/GM/Buick PTS

for a 2018 chevy Equinox for remote start
...