The current consumption from the battery 2A but when the engine is muffled from the key

Question

1. Ford Kuga car of 2016 until the last restyling, automatic transmission, PST.

2. Installed Fortin 6 №001A06757538, firmware version 71.43.
3. All necessary commands are executed, but when the engine is muffled from the key, the car turns off the engine, turns off the radio, turns off the screens and is armed. The current consumption from the battery 2A and does not change for a long time (more than 2 hours). which leads to discharge of the battery. In the standard mode, after 15 minutes, the current is 0.03A. Obviously, the car does not fall asleep when working with Fortin.
4. Fortin installation was made according to the scheme 34911. The question on the connection of the connector B, if there is no RF, it is necessary to connect B3 and B4 to ground and 12V respectively? The lack of such connections can affect the fact that the car does not fall asleep?
5. Recommend the firmware version of Fortin for correct operation with my car. Maybe it's 71.39? Will the car sleep properly with it, or does the version of the firmware affect it?

Vladimir.

 

Answer 1

The software does not have effect on the power consumption. The module will go sleep at the same time the vehicle sleep. Disconnect the remote starter, and test the current consumption of the vehicle. Ford will take 30-45 minutes before lowering consumption. Hood must be closed to test properly, you can latch the hood.

Answer 2

The check was carried out, the car falls asleep after 15 minutes (consumption 0.03 A), when the unit is connected and the engine is muffled, the key does not fall asleep after 1 hour. Therefore, the question arose with the software.

Answer 3

The question on the connection of the connector B, if there is no RF, it is necessary to connect B3 and B4 to ground and 12V respectively? The lack of such connections can affect the fact that the car does not fall asleep?

Comments

B3 and B4 are the wires that feed power to the module and they are necessary YES. The red and the black wires in the B connector entering the connector must be connected.