Data-link SANS connector

Question

Im not using a RF-KIT, so In the guide 32791 page 5 it shows the Data-link connector B3 and B4 is cut and ran to a +12V and to ground.  Is this suppose to be done if RF-Kit is not used, does these wires need to be cut and stowed or cut and attached to +12v and neg.?

Answer 1

If you are not using a remote starter you cut the connector of the end of the data link cable and wire the red to 12v and black to ground.

Answer 2

it's a bilingual guide. French and Enlgish. the word SANS is french for without.

 

Datalink is a communication protocol between a bypass module and a remote starter/alarm. The connector itself is what supplies power to the unit (red and black wires)