My grand caravan 2015 sensor Gate on and all the lights on after the installation of evo-all

Question

After the installation of the Evo-All CHRT4, my Dodge Caravan 2015 have the GATE indicator on on the dashboard and all the internal lights on too. What can I do?

Answer 1

If you disconnect the t-harness from the vehicle, is the problem still there ? If the vehicle think the gate is open, it will leave the domelight on that is normal. Sounds like something is misconnected or maybe a connector is not fully inserted.

Comments

Yes, if I disconnect the module, the gate indicator stay on. I test all the plugs an are well connected. Is mandatory install the hood pin and the valet switch?

---

Not mandatory but highly recommended, however if it's not installed this is not what's causing your gate problem.

Did you make sure the tailgate was actually closed properly ?

Try disconnecting completly the t-harness and put the vehicle back to stock. Fix the gate problem and then reinstall the remote starter.

Answer 2

What wires on the 20 pin connector did you use? Please post your 12 digit service number so we can take a look at the options and firmware you currently have on the evo unit.

Comments

No. 001A06647962

I used A1 and A14