E400+EVOKEY-Rio 5 2011 manual transmision ready mode not working

Question

Hi,

When i try to put in ready mode, the parking light flash 8 times.  Anyone now what this mean?

I tried to cut the loop for testing and the remote start work with the clutch pedal press. (So now i have to find a bypass for the safety switch, wirecolor says negative so i will probably use starter yellow black)

I did the tach learning and at the end i'm getting the parking light flash 3 times. (Is this correct?)

The dark green wire (Door pin) is connectec to the green wire on the driver kick pad.

The brown wire (hand brake) is connected to green orange

The grey (hood) is connected to the brown on the blue connector.

Trunk pin not connected

 

Any help would be appreciated.

Thanks

Answer 1

Test your connection with a digital multimeter to make sure they are correct.

Yes the 3 parking light flash when exiting programming is normal.

Comments

Hi,

Thanks for the reply.

To be honest, i did test with a fluke multimeter and all seem to match.

Can i disconnect the door, hood and e-brake and see if the ready mode works?

---

In automatic mode and the door is open, the remote starter does start the car. Is this normal?