unlock and lock outputs stand alone

Question

Well Ive connected the lock and unlock wires from evo all to the vehicle , green and white from evo all to violet and red from vehicle ( Infiniti qx56 2012) 12 v when rest and 0 v when pressing lock or unlock ) after that I gnd the external outputs from evo , light blink one time blue and nothing happened, so what support to do the evo? I've also test the lock and unlock wire from evo while I und the outputs but nothing happens . suggestions and advices are welcome

Answer 1

The lock and unlock wires on that car are in the driver door.

• Lock is RED
• Unlock is GREEN (must be programmed for double pulse unlock)

 

Simply grounding either one of the above wires will lock-unlock the doors. This can actually be connected either to the remote starter or directly to the GREEN and WHITE wires on the EVO-ALL (if using stand alone remote start).

 

Comments

Thank you Robert for the answer , but this is exactly what I did , connect both wires from the vehicle to the white and green wires from evo all, and then try to activate them by grounding the outputs on the evo. when I ground the outputs the eco blink blue one time like support to be , but no negative pulse going out from the green or white wire from eco all to the vehicle .

---

the wires colours from the vehicle are red for lock and white for unlock , no need to disamble the driver door, you can find them at the harness going from the car to the driver door. you can check the wiring color for this vehicle images 19 and 20 . also test them, when rest 12v when lock or unlock 0 v

---

what's the service number on the EVO? If the EVO-ALARM feature is enabled, the lock and unlock outputs on the EVO are used for something else.  That's the only thing I can see at the moment.

---

Thanx for the answer Robert, the evo alarm is not selected , here you are the service number of the second car that I've just programmed , everythink works fine except lock and unlock outputs 001A06 129407, do you think that after selecting the options need to reprogram ? Not make sense , everything works fine , even the start stop output. by the way I've tried to inputs gnd on the purpule and white purple , the module blink blue one time like it's doing the action, but again locks and unlock remain same . and this is the first vehicle:001a06129413, both works great. thanx Robert for your support

---

I'll be honest, I think you may just be on the wrong wires. It may look like the right wires, but they are on the wrong side of the switch for lock/unlock. You need to go in the door. The signal you want come from the "Door Key Cylinder Switch".

 

If you ground either RED or VIOLET (on the vehicle) that you are connected to, the door locks should Lock/Unlock. In your original question, you did mention that you tried grounding these wires but nothing happened. Something should happen if it's the right wires.

 

 

 

---

I will try to check the wires in the door and let you know , what you are saying making sense . did you try to attach some pictures ? Nothing appearing

---

I attached the vehicle schematic and for some reason they do not show up if you are looking at this post from fortin.ca and not wirecolor.com :(

 

Try from here, http://wirecolor.com/en/qa/54683/unlock-and-lock-outputs-stand-alone

---

Now yes :). Thanx I will let you know .

---

Little note, I said RED and VIOLET for some reason, not sure why. Wires should be RED and WHITE for lock and unlock.

---

Some says green, some says white and others says violet :). I will test them all and let you know . Thanx again Robert