Why blue and red flashing LED after programming 1st key bypass on Evo All on 2014 Mazda CX5?

Question

I am using guide 62951 to program the Evo-Mazt1 to an automatic push button start 2014 Mazda CX5. I have verified continuity to the door lock data and data key wires. When following the key bypass programming procedure it works fine until I get to step 6 on page 9 to learn the first key.  Yellow LED lights up briefly then immediately starts flashing red and blue continuously. I have tried using the flasher to re-save the settings. Have tried taking the battery out of the key/fob. Sometimes it stays blue. Sometimes it flashes red and blue.  Any help is appreciated.  SN: 00A06 843321

Answer 1

Please reset the module and flash version 71.47. 

Reset procedure found here:

1. Hold down programming button while plugging in datalink connector.
2. Let go of button when LED is RED.
3. Push and hold button again until all three LEDs start to alternate.
4. Disconnect unit, it is now reset.