Questions & Answers

How to hook up auto light shutdown on 2011 Nissan Pathfinder with Intel key

0 votes
I am using an EVO-ONE.  I hooked the Dark blue from pin A8 to the driver door pin listed on wirecolor as the gray wire at pin 7 on the BCM in the white 15 pin plug.  If that wire is hooked up the vehicle starts, then immediately shuts off.  I left it disconnected until the customer comes back this Sunday so I can try to figure out what is going on.  Remote start operates fine with it disconnected, but the lights do not shut off which will cause battery issues.  I do not have the service number on hand.

How do I hook up the wire to shut off the autolights?  Is it possible that the gray is the wrong wire?

Also on the wirecolor site it says the autolight shutdown wire is purple at the parking light harness but it is supposed to be cut.  The install guide says to hook it up to the door pin.
asked Nov 23, 2016 in Nissan by Daniel Waslenko (2,650 points)

1 Answer

0 votes
Option 32 must be set to mode 3 in the remote starter options.

You should use the doorpin wire as shown in the install guide.
answered Nov 23, 2016 by Daniel Waslenko (85,210 points)
...