Questions & Answers

2015 Wrangler Unlimited install

0 votes
I have a 2015 Wrangler Unlimited with automatic transmission and want to install a stand alone EVO All with the T harness and want to know exactly the bare minimum to install the remote start. I am looking at install chart C and the T harness is easy and the 20 pin on the EVO All looks like the only thing you have to wire is the yellow ignition wire to the yellow ignition wire on the T harness? Is this correct? The hood pin and the parking lights look like they are optional and don't HAVE to be hooked up.
posté Jan 13, 2015 dans la catégorie Jeep par Russell Hastings (200 points)
modifié Jan 13, 2015 par Russell Hastings

1 Réponse

0 votes
The 2015 Wrangler has not been tested yet, We do cover up to 2014. You will need a Flashlink-2 programmer to be able to flash firmware into your Evo All and change options to turn on Stand alone mode.

We cannot guarantee that the 2014 solution will work on your 2015, I suggest you wait until a solution is posted on the Fortin.ca website
répondu Jan 13, 2015 par J M (64,060 points)
I bought it from you guys and it has already been programmed, I just wanted to know if the yellow wire is the only wire that has to be done along with the T harness to make the stand alone remote starter work.
Nevermind about bought it from you guys, I thought I was talking to the company I bought it from.
if you want to try it anyway, you ONLY need to connect the yellow wire, DO NOT CONNECT the green/red from the 20 pin connector to the purple wire of the t-harness
Great, that's what I thought but I just wanted to make sure. Thanks for the help.
The options for the stand alone need to be enabled for 3x lock to work. So besides for the yellow wire, you need to make sure options are enabled. This has to be done at the time of installation.
...