Questions & Answers

Mazda 6 2015 installation question!

0 votes
I installed the Evo All into my girlfriend's 2015 Mazda 6 and I'm having some trouble. I used the guide for the one key programming and got it to program successfully, when I hit lock 3x the module red light comes on, followed by the yellow led, which stays on for a few seconds and then turns off, then the red. Then the red led comes on again, followed by the yellow, and then back off again. After this the red led flashes three times and then shuts back off. I have it hooked up with the T Harness, and everything that needs to be hard wires is hard wired per the T Harness guide. Can anyone tell me what I need to do to get this to work? It's acting like the module is trying to remote start the vehicle, but somewhere along the line the signal just gets cut off so the vehicle never actually cranks. Thanks for any help!
asked Sep 24, 2016 in Mazda by Zack Pendleton (160 points)
edited Sep 25, 2016 by Zack Pendleton

1 Answer

0 votes
Can you tell me which t-harness you have?

 

if it is a MAZ-1, the you followed the wrong guide. you need to use 2-key programming. Please do a master reset and follow the programming procedure as shown in the guide. Depending if the vehicle has an OEM alarm, then you need to choose between connections 1, 2, or 3

 

3xlock start is not supported on 1 key programming and requires either MAZ-2 with an Evo ONE or a complete separate remote starter connected wire to wire.
answered Sep 26, 2016 by J M (64,060 points)
...