Module turns off after plugging the 20-pin connector

Question

After installing the wiring I tried to program the module. When connecting the 20-pin connector the blue LED turns off on step 3. This only happens with the 20-pin connector, the others are fine.

 

2013 Toyota Camry SE V6 with PTS.

Answer 1

This means that their is 12 volts present on the yellow wire(A1) and this wire should only have 12 volts when the ignition is turned on...

Test / Verify connection to the yellow wire (A1)

No key in ignition = 0V DC

Ignition in the ON / Run position = 12V DC

Comments

Thanks for the suggestion. Turns out I hooked up the light blue wire instead of light green.

Now I have another issue. When programming on step 4 the LED does not blink 3 times, it just turns off after pressing PTS button the second time. First press it's still on but on second press turns off.

 

***EDIT***

Apparently I screwed up the wiring on the other connector as well. Finally I was able to program the module and it responds to the key fob. The only problem now is the car won't start. It tries to start a couple of times (no engine crank) and that's it.

---

if the ignition turns on but no crank, please verify your connections to the (-) steering lock wire on the steering lock connector, wire is Pink and is in the middle pin of the 7 pin connector.

Do you have a flashlink updater-2

---

Thanks will be checking the wire in a bit. No I don't have flashing unfortunately.