Dcryptor does not complete - No connection avalaible msg after 1hr+ decription

Question

Hi,

I have followed the guide religiously several times now and have even performed a "Master Reset Procedure" a couple of times along the way.

Everything seems to work according to the guide:

• Programming: I obtained the red and yellow flashing lights before heading to the computer to run the "Decryptor."
• Decryptor: I received the Flashlink updater status: "Connected," as well as the same for EVO-ONE.

I tried two different computers (one with a very fast internet connection).

After a very long time (1+ hour), an image appeared saying "No connection available" and the following message:

The application is currently unable to load files from the server. Please try again later. If the problem persists, please contact customer support.

And here I am…

Flashlink service number: 002505 118533
EVO-ONE: 002B04 663520 (number printed on the machine*)
01/2024

*However, when I click on the "Bug Report" (top-right), I obtain a pre-filled form that shows two serial numbers:

• EVO-ONE Bypass model: 002B04 663520
• EVO-ONE Remote Starter model: 002B07 663520

Please help!

Oh... While at it, I should be getting close to my EVO and other limits... if you could reset them please.

Answer 1

Hello,

There is currently an issue with the flasher/dcryptor.

Please try again tomorrow, your patience is appreciated.

Best regards.

Comments

Thank you!

I will try again tomorrow.

---

Good evening,

The Dcryptor finally completed the work. Thank you!

After instalation, the remotes will not work or do anything anymore...

Batteries are fresh and they worked before I started this project.

They will not lock/unlock the doors, open the trunk or start the car as intended.

Other thing that is weird, the dashboard now says the handbrake is malfunctioning...

Please help,

---

Upon further tests... dome lights, headlights and other equipments is not working anymore.

Please help!