DCryptor procedure / Acquire data - Evo-One module

Question

Hi,

I forgot to Acquire data from the car and the module Evo-One was already updated, so during the installation page 6/10 step 4 the BLUE LED switchs off when i turn the ignition ON  https://cdn02.fortin.ca/download/77141/evo-one_ig_thr_bi_aud1-a4-a5-q5-s4-s5_2015_pts_a_77141.pdf 

So i am wondering if i should to do factory reset the module AND HOW to do it! According this answer https://fortin.ca/en/qa/67178/evo-one-reset the module must be installed on the vehicle which is not in my case.

I could'nt find those following connecters:

12. immobilizer data purple/blue

17.  start/stop black/blue

18. start/stop 2 black/red

19. start/stop 3 grey/blue

25. key release Grey/yellow

and more.

Answer 1

Those connections are part of the T-harness.

The only connections you need to do are the ones in the guide. CAN high, Can low and brake.

 

The blue light is not flashing because there is a problem with your CAN connections.

 

The reset can be done in the car but not while it is connected to flash link.

 

Altough a t-harness can make things look simple, consider contacting a local professional to simply have the system installed professionally.