Questions & Answers

2013 Dodge Ram

0 votes
2013 dodge ram tip start

 

I'm using the "glacier start" remote starter kit from Grand West Enterprises.  It said I needed to connect the yellow ignition wire to the ignition source at the brake controller harness.  I tested it and it does get power on ignition.  I don't know what else to try.
asociée à une réponse pour: can bus program stays blue
fermer comme doublon de: Programming EVO-ALL
posté Nov 4, 2013 dans la catégorie Dodge par Ken Making (310 points)
fermé Nov 4, 2013 par Robert T2

1 Réponse

+1 vote
 
Meilleure réponse

In this programming procedure, there are a few steps to follow and a minimum required firmware.

 
What is the 12-digit service number written on the back of the EVO?

Are you using a T-Harness (THAR-CHR3 or THAR-CHR6)?

 

Note: reply by using the comment button below

répondu Nov 4, 2013 par Robert T2 (299,010 points)
élue Nov 19, 2013 par Robert T2
Service Number
posté Nov 4, 2013 dans la catégorie Dodge par Ken Making (310 points)
fermé Nov 4, 2013 par Robert T2
Really, the only reason it normally stays on Solid is because it does not see ignition On. If the Can-Bus was at fault, then the LED would shut off and stay off.

I'd recommend disconnecting the 20-Pin white connector from the EVO-ALL, and with a multi-meter, test the voltage on the Yellow wire.
commenté Nov 4, 2013 par Robert T2 (299,010 points)
modifié Nov 4, 2013 par Robert T2

Questions associées:

...