2016 camry Hybrid

Question

Hello. On 2016 Camry 2 pcs Evo-All I wanted to be programmed and on both after turning on the ignition after 10 seconds the red LED starts blinking. 001A07579416

Answer 1

Hello,

Yellow flash = issue with lt.blue/black wire on evo-all

Red flash = issue with lt.blue wire on evo-all or vehicle is equipped with an OEM starter.

 

Issue will revolve around rx and tx connections it sounds like or the car has an oem starter in it already.

 

Best regards.

 

Comments

A week ago on a Lexus I removed the DCM fuse during programming and it helped. Is there a similar fuse on this car?

---

possibly, the fuse would be labelled either dcm or mayday. Fuse 21 on the interior fuse box. You could try removing it and re programming the module with it removed.

---

But the 21_mayday- socket is empty (in the bonnet space). The bonnet button is there and it is OK.

---

In that case I would look at the rx and tx connections or see if it is equipped with an oem starter.

Otherwise you could try rolling the fimrware back to something older such as 79.57 and re attempt programming.

Best regards.

---

57 didn't help either. The OEM starter is also not where it should be. The car was flooded in water, and as can see, the BCM is installed from another car...

---

I released the button on red. Pressed the button once. Turned on the ignition. Red blinked 10 times and blue started blinking. Turned off the ignition. Then released it on blue and after turning on the ignition blue started blinking (as expected). Pressed on the remote 3 times (blue reacts). Red turned on and after 10 seconds red blinked 4 times and nothing else.

---

Now 3 times