Questions & Answers

Unable to Program keys, Decryptor indicates missing information.

0 votes
2018 Ford F-550 Standard keyless entry.  Installed EVO-ALL 4.01 Stand Alone THAR-FOR3 Single key: Truck starts and runs with the FACTORY 3x Remote start option (Verifies CAN communication).  The runtime is not adjustable with this installation method.  Installed EVO-ALL 4.01 & 71.50 Stand Alone THAR-FOR2 2-key and cannot get past Key programming to get Decryptor set up.  Using either 4.01 or 71.50 Firmware and guide# 59421,at step 5 where after installing the first key the red LED should flash, the red LED turns on solid. After inserting 2nd key the red and yellow LEDs turn solid and the ignition turns on BUT the blue LED never flashes and the ignition never turns off.  The IP indicates that there is no key present.  The only way to turn off the ignition is to unplug the black 4 wire connector (Data-link) from the EVO-ALL.  I have verified CAN communication on both CAN1 and CAN2.  Both keys are master keys that were supplied with the truck at new delivery.  I have been through the troubleshooting section and that was no help. I found a post in the forum "FORT2 Programming Issues" that had an issue similar where the CAN2 was disconnected to solve the issue, I have not tried this yet.  Is there anything else that I can try to get the Keys to allow programing so that i can run the Decryptor portion of the EVO-ALL programming?  I have exhausted all ideas except for the disconection of the CAN2 as a last resort.  Thanks again, cheers.
posté Jan 2, 2021 dans la catégorie Ford par Kutech (760 points)

1 Réponse

–1 vote
No Decprtion key required its 1stage programming.
répondu Jan 3, 2021 par Haidar Jabbar (22,390 points)
Step 10, 11 & 12 are for the Dcryptor programming.  I now have the ignition turning on and the truck wants to crank but the IP indicates "No Key Present".  I cannot get the EVO-ALL to get to the point where after turing on both keys the Blue LED flashes and then disconnecting to program the Dcryptor.  I have verified that the 2 keys I am using are ADMIN keys.  I have disconnected the CAN2 wires, that has given the EVO-ALL the ability to now turn on the ignition.  Any other ideas? Thank you.
...