Questions & Answers

Programing won’t flash 10 times help

0 votes
2020 forester when programming when I start the vehicle it won’t rapidly flash 10 times. Help
posté Jan 12 dans la catégorie Subaru par cedrickxavier@gmail.com (130 points)

1 Réponse

0 votes
Hello,

If a SUB3 t-harness was used then you would want to verify the imo connection.

Also make sure the jumper was plugged into connector B and connector A was plugged into the t-harness section that goes to the fuse box as indicated in the installation guide: https://cdn02.fortin.ca/download/99391/EVO-ONE_IG_RTO_BI_SUB1-SUB3_FORESTER_2019_KEY_A_99391.pdf

Best regards
répondu Jan 13 par derek g (355,580 points)
I only have the sub 1 harnest
commenté depuis 21 heures par cedrickxavier@gmail.com (130 points)
In that case you will want to verify your IMO connection as well as the can bus connections. Something is not right with these wires if it is not programming.

Also be sure you loaded the module with firmware 84.12.

Best regards.
commenté depuis 9 heures par derek g (355,580 points)

Questions associées:

...