Questions & Answers

Evo one won't go to valet mode

0 votes

Evo one is NOT going to valet mode. I have all the wires checked, good ground to the module and ignition reading 12V. My issue is that evo one is doing any thing after I programmed it, NO lights at all on both sides bypass and remote starter. Anyone who can help me with the issue that I have.

service no:  002B07  100211

asked Oct 20, 2019 in Toyota by Hermon Gebreslassie (160 points)
edited Oct 21, 2019 by Hermon Gebreslassie

1 Answer

0 votes
What is the service number or S/N to the module?
answered Oct 21, 2019 by derek g (347,950 points)
Service No : 002B07  100211
commented Oct 21, 2019 by Hermon Gebreslassie (160 points)
valet mode requires 3 things, power ground and a switched ignition. If you have verified these three things I would meter the valet button to make sure it is not open all the time.
commented Oct 21, 2019 by derek g (347,950 points)
valet button tested with ohm meter works fine.
commented Oct 22, 2019 by Hermon Gebreslassie (160 points)
Then looking at your vehicle (06 corolla), I would suggest verifying either you foot brake wire or parking light wire. There is an issue with one of these 2.
commented Oct 22, 2019 by derek g (347,950 points)
They're both working, I do have continuity and voltage reading.
commented Oct 24, 2019 by Hermon Gebreslassie (160 points)
I suggest calling us at your earliest convenience  so we can verify the installation with you.

1-877-336-7797

Mon-Fri

8-6 EST.
commented Oct 24, 2019 by derek g (347,950 points)
The guy is not helping on the phone.
commented Oct 31, 2019 by Hermon Gebreslassie (160 points)
Is there any way to test evo one module out of car. I think it's malfunctioning.
commented Oct 31, 2019 by Hermon Gebreslassie (160 points)
All the module needs for valet mode is power - ground - ignition. It does not even need to be installed a car.

 

Ignition On, press 3x times on valet button, ignition off.
commented Oct 31, 2019 by Robert T (302,310 points)
I bought another one, it worked for two days and then blew up. I don't know why?
commented Nov 14, 2019 by Hermon Gebreslassie (160 points)
Module blowing up = installation problem.
commented Nov 14, 2019 by Robert T (302,310 points)
Service No: 002B07 302835
commented Nov 15, 2019 by Hermon Gebreslassie (160 points)

Related questions

...