adding led flashing light to system.

Question

I had asked this before. I was told that the white wire in the 20 pin connector goes to ground when the system is armed. This is untrue on my module. I have it set to stand alone with alarm activated. I tested all wires for a ground when armed and i get none. So is there any other solution to add a flashing led to this system as other alarm systems have. Also i seen that you offered a shock sensor siren kit at one time called FSS-SIREN. i have been unable to locate this set. Is it still offered?

Answer 1

Yes FSS-SIREN is still available, you should contact your supplier.

Yes the white wire is starter kill output. The alarm will take approx 15 seconds to arm after hitting lock. Wait this delay with all doors/hood closed.

Comments

ok i tried that. led still doesnt come on.  im using the Directed 620V. maybe something is wrong with my module.

---

i have been reading other posts with the same issue. is there a way to get this resolved???