blowing 2 amp fuse?

Question

I have the evo-all connected using the "F" guide and it works as far as starting my truck after hitting lock x3 but when I do use it, it blows my 2 amp fuse for IGN Switch Feed fuse.

Answer 1

Are you using a t-harness ? The guide ask to cut the yellow/red and then run the connector side of the wire to the start wire.

Verify all your connections at the ignition connector, something is wrong.

Comments

Ahh yes. That is my problem, I have the wrong end of the yellow/red wire connected to the ignition. Thank you so much, glad it was an easy fix. I will make the change tomorrow and post my results!