I have a 2008 ford taurus x and i recently purchased the evo all to install as a remote start. after doing research i noticed the taurus x didn't come with a t-harness so i went ahead and ordered the thar-for1 and after the hook ups it didn't run. I an put the 4 pin harness in and stop on the blue light, hook the remaining pins up, put the key in the ignition and it will flash blue lots of time. Then i'll go to step 2 hooking the 4 pin connector back in while holding the button and stopping on the red. I then put the first oem key in and turn it to the on position and the yellow light turns on and then the red light flashes once, i then turn key to the off position and the yellow light turns off. So i put the 2nd key in and it blinks once and after 3 seconds just like the first key i turn it to the off position. I then push the button so that the red light will start flashing but for some reason it will not!! if i unplug the 4 pin connector and plug it back up and hit the lock button 3x's the blue light flashes everytime u hit the lock button and after the third time the red light comes on followed by the yelllow light in which it seems like you think it will start cause it starts it chimes, but it does nothing at all? i've hooked the ignition, rx,tx,wires up on the 20 pin. i've even hooked the red blue wire to the start, i've ground the yellow and black wire, and even ground the gwr wire and still it does nothing. i've got the flash linked and i checked everything and have it set to pretty much the way i want it, and it has the all the latest firmware and all that done. i've even took the t-harness out and w2w this evo all and it still does the same thing...
