Questions & Answers

2010 Toyota Sequoia Power Lift Gate

0 votes
I recently installed the Evo-one along with the rfk942 remote/antenna.

I wired the Evo-one as per https://fortin.ca/download/85241/evo-one_ig_reg_bi_toy-sequoia_key_2008-2009_a_85241.pdf

Am I able to operate the power lift gate with this combination?
asked Jan 13, 2022 in Toyota by gullygossner (230 points)

1 Answer

+1 vote
 
Best answer
red wire at the liftgate switch is the trigger.

You can use the (-)Trunk output, Yellow/Black from the evo 20-pin and wire it straight to that.

Always test the vehicle wire first! It should be a negative trigger.
answered Jan 13, 2022 by Robert T (300,020 points)
selected Feb 25, 2022 by gullygossner
Thank you for the answer Robert! Does it require any changes on the firmware side?
commented Jan 18, 2022 by gullygossner (230 points)
So I wired it up as specified but it doesn't activate the power hatch. The gate will release when pressing what I believe is the aux 1 routine but i cannot activate the power hatch.
commented Feb 23, 2022 by gullygossner (230 points)
edited Feb 23, 2022 by gullygossner
Increasing the pulse time to 2.5s solved this.
commented Feb 25, 2022 by gullygossner (230 points)

Related questions

...